26 November, 2011

Gundam 00: Waist 2

This really should have been open and shut as far as build is concerned. Anyway, the waist is pretty close. Some more bits here and there would be nice.

mobile suit gundam 00 double 0 raiser riser 3d mesh cg sandrum

Labels: ,

19 November, 2011

Gundam 00: Waist 1

Normally I just plow through the waist section because it's usually is the easiest part of the gundam to make -- essentially being a large center object anchoring a few smaller ones. But I've got lots of code to write this weekend, so...no.
I only really started it so it looks quite primitive...aye

mobile suit gundam 00 double 0 raiser riser 3d mesh cg sandrum

Labels: ,

15 November, 2011

Gundam 00: Body 2

Compartmentalized some the the armour and the frame underneath. Still need to move some parts around and get back to the head and then get to the cockpit if possible. I hope I can knock out the waist soon-ish.
Edit-- forgot some detail around the rear cylinder.

mobile suit gundam 00 double 0 raiser riser 3d mesh cg sandrum

Labels: ,

12 November, 2011

Gundam 00: Body 1

I'm working on trying to get back to the Kshatriya as well as the 00, but time is really lousy these days. So much to do and so little time. Started the bits of the torso here but there isn't much to look at other than sliced up primitives and a lot of covered up holes in the mesh.

mobile suit gundam 00 double 0 raiser riser 3d mesh cg sandrum

Labels: ,

03 November, 2011

Gundam 00: Head 2

I've really got a lot of other work to do so this will be slow going.
My target in this one is a little different but the head is coming along.
I had a few ideas for detail but I'm holding them back for surfacing. I'll probably
bump map the rest of the hard-line detail near the head sensors. Otherwise..it went "okay".

I still have to drop the center section of the gold antennae and sharpen the edges to points, as well as cut out the ear disks on the lower back away from the head. Maybe add the camera block on the front of the head sensor. Not sure about the text on the red sensor... I might just texture that. The rest will be mapped after the build.

mobile suit gundam 00 double 0 raiser riser 3d mesh cg sandrum

Labels: ,